Luce PT-L6510E - Manual (Page 36)

36
Deleting User Mode
(e.g. Deleting the data of “USER1”)
1. Choose “USER MODE” on “OPTION2” and press
the “ENTER” button.
2. Choose “DELETE” using the or buttons.
3. Choose the address (USER1) you want to delete
data from using the or buttons and press the
“ENTER” button.
4. After recorgnizing the flashing of the address
display, press the “ENTER” button again to delete
the data of the address.
Registering/Deleting/
Displaying User Mode
(For RGB/YP
B
P
R
signals only)
Once adjustment settings are registered with User
Mode, they are automatically loaded each time the
projector is powered up. It is not necessary to readjust
settings at every power on.
Registering User Mode
(e.g. Registering positioning data with “USER1”)
1. Apply an input signal you want to register, and
then adjust the picture position, size, and others.
2. Choose “USER MODE” on “OPTION2” and press
the “ENTER” button.
3. Choose “USER1” using the or buttons and
press the “ENTER” button.
4. After recognizing the flashing of the USER1
address display, press the “ENTER” button again.
5. The above adjusted settings has been registered
with “USER1”. Similarly you can also register
settings with “USER2” or “USER3”.
SETTING UNIT ID
UNIT ID is used to set projector IDs when the user
wishes to control two or more projectors either
simultaneously or separately.
"ALL": The projectors can be simultaneously
controlled from any remote control regardless
of their ID settings.
"1": The projector can be controlled from the remote
control with its projector ID set to “1”.
"2": The projector can be controlled from the remote
control with its projector ID set to “2”.
"3": The projector can be controlled from the remote
control with its projector ID set to “3”.
Note
• Unit ID is set to “ALL” by default. Hence ID
number need not be set when only one
projector is used.
• If the projectors are given ID numbers, their
remote controls must be assigned the same
ID numbers, respectively.
• If the unit IDs of two or more projectors are
set to “ALL”, the user will not be able to
control them separately.
• The projector can be turned ON/OFF from
the remote control only if the projector ID is
set in the remote control. For the details of
projector ID setting, see page 15.
SET ID ALL
1
2
3
USER MODE
ENTRY USER1
SELECT ADJ ESC
USER MODE
ENTRY USER1
DELETE USER1
SELECT ADJ ESC
OPTION 2 settings
Displaying User Mode
The User Mode can be displayed by following the
steps described in “SIGNAL MODE” on page 31.
Note
• The user address has “USER1” to “USER3”.