Luce PT-L6510E - Manual (Page 42)

42
Notes when replacing the lamp unit:
• The internal pressure of the light source is high, therefore if it is struck by hard objects or dropped, it may cause
damage. Be careful when handling.
• Handle the old lamp unit with care as it is easily broken.
• A Philips screwdriver is necessary when replacing the lamp unit. Be careful not to slip when using the screwdriver.
Replacing the lamp unit
Caution!
Replace the lamp unit only after it has
completely cooled off.
Caution!
Replacement of the lamp unit should
only be carried out by a qualified
technician.
Lamp replacement period
The light source lamp of this projector has a life cycle of 2000 hours (Lamp power---hi, Lamp selection---dual
setting). However, this duration may be reduced depending on the usage of the projector-the frequency in which
the light is turned on and of its intervals affect the life of the lamp. Therefore it is recommended that a spare lamp
be made available before 2000 hours have elapsed. If the lamp unit is not replaced after 1800 hours, the power will
automatically shut off after 2000 hours and enter standby mode. If the power is turned on after 2000 hours, it will
turn off automatically after approximately 10 minutes and enter standby mode.
Caution
• The lamp unit is sold separately. Please consult the service/parts centre at your dealer.
• Lamps other than those indicated above must not be used with this projector. Be sure to use the specified
lamp.
• Display after 1800 hours
The lamp monitor indicators (LAMP 1 or LAMP2)
will light after the lamp unit runtime has elapsed
1800 hours even during standby mode.
A n o n - s c r e e n m e s s a g e i n d i c a t i n g l a m p
replacement is necessary will be displayed on the
screen 30 seconds.
(This on-screen message will disappear after 30
seconds or the projector operation buttons remote
control buttons are operated.)
This on-screen message does not disappear,
unless a “MENU” buttons or sound adjustment
“(VOLUME +/-)” buttons will be pushed, if it
reaches in 2000 hours.
S-VIDEO
AUTO REPLACE LAMP
Model No.
PT-L6510E
PT-L6600E Lamp unit model No.
ET-LAL6510 (1 lamp) • ET-LAL6510W (2 lamps)
Note
• 2,000 hours is a guideline for replacement, not a guarantee time.