Lenoxx Electronics PH5435 - Manual (Page 9)

IB-PH5435-WC-E-032805
While the first digit is flashing, you should:
1. Press the UP or DOWN button till the
first digit of your area code is displayed
(flashing).
2. Press the DELETE button to accept
and go to the next digit.
3. Repeat above steps 1 and 2 to set the
2nd and 3rd digits of your area code.
Step 3: Setting up the Telephone
AREA CODE
E X A M P L E :
718
Press UP/DOWN & DELETE
GETTING STARTED
SETTING UP LCD CONTRAST, LANGUAGE, AREA CODE,
TIME & DATE, AND TONE OR PULSE MODE
You may need to set up the LCD contrast, language, area code,
time and date, and tone or pulse mode for your telephone when
you install the batteries for the first time or when you move to an
area that has a different area code. This is necessary because the
phone must distinguish local or long distance calls to properly dial
calls from the Caller ID list.
Press and hold the DELETE button, then press
the DOWN button, the LCD CONTRAST (5-
grey level) will show in the display. Use the
UP or DOWN button to select the suitable grey-
level and press the DELETE button to accept.
Afterwards, your phone will now go to the Time and Date mode,
press the UP or DOWN button to get the correct number and press
the DELETE button to accept. Then the phone will ask you to
select Tone or Pulse mode, press the UP or DOWN button to
select your desired dialing mode(“>” flashes before it) and press
the DELETE button to confirm until the normal display shows.
7
Press UP/DOWN & DELETE
Press UP/DOWN & DELETE
NOTE: During setup, if you do not press the DELETE button within
20 seconds, the display will get back to normal display
mode.
Then SET LANGUAGE will show in the
display, the default language “E” (English) will
flash. Press UP or DOWN to choose your
desired language (flashing). Press the
DELETE button to confirm and accept.
Your phone now will ask you to set your
Area Code:
“E” = English;
“F” = French;
“S” = Spanish
IB-PH5435-WC-E-032805.pmd 4/1/2005, 12:28 PM 9