Lincoln Electric POWER FEED IM916 - Manual (Page 30)

b-12 OPERATION b-12
POWER FEED™ 10M DUAL WIRE FEEDER
USER DEFINED PARAMETERS
Parameter Definition
P.99 Show Test Modes
Most power sources contain weld modes used for calibration and test purposes. By default, the machine
does not include test weld modes in the list of weld modes that are available to the operator. To manually
select a test weld mode, set this option to "Yes". When the power source is turned off and back on again,
the test modes will no longer appear in the mode list. Test weld modes typically require the machine out-
put to be connected to a grid load and cannot be used for welding.
P.100 View Diagnostics
Diagnostics are only used for servicing or troubleshooting the Power Wave system.
Select "Yes" to access the diagnostic options in the menu. Additional parameters will
now appear in the setup menu (P.101, P.102, etc).
P.101 View Event Logs
Used for viewing all the system event logs. Press the Right Button to enter the option. Rotate Control
Knob to select the desired event log to read. Press the Right Button again to enter the selected log.
Rotating the Control Knob will scroll through the event log, displaying the log index number, event code
and some other data. Press the Left Button to back out to select another log. Press the Left Button again
to exit this option.
P.102 View Fatal Logs
Used for viewing all the system fatal logs. Press the Right Button to enter the option. Rotate Control Knob
to select the desired fatal log to read. Press the Right Button again to enter that log. Rotating the Control
Knob will scroll through the log, displaying the log index number and fatal code. Press the Left Button to
back out to select another log. Press the Left Button again to exit this option.
P.103 View Software Version Information
Used for viewing the software versions for each board in the system. Press the Right Button to
enter the option. Rotate Control Knob to select the desired board to read. Press the Right
Button again to read the firmware version. Press the Left Button to back out to select another
board. Rotate the Control Knob to select another board, or press the Left Button to exit this
option.
P.104 View Hardware Version Information
Used for viewing the hardware version for each board in the system. Press the right MSP
Button to enter the option. Rotate Set knob to select the desired board to read. Press the right
button again to read the hardware version. Press the left button to back out to select another
board. Press the left button again to exit this option.
P.105 View Welding Software Information
Used for viewing the Weld Set in the Power Source. Press the Right Button to read the Weld
Set version. Press the Left Button to back out and exit this option.
P.106 View Ethernet IP Address
Used for viewing the IP address of Ethernet compatible equipment. Press the Right Button to
read the IP Address. Press the Left Button to back out and exit this option. The IP address can-
not be changed using this option.
P.107 View Power Source Protocol
Used for viewing the type of power source the feeder is connected to. Press the Right Button to
identify the power source as either LincNet or ArcLink. Press the Left Button to back out and
exit this option.