Lincoln Electric POWER FEED IM916 - Manual (Page 33)

b-15 OPERATION b-15
POWER FEED™ 10M DUAL WIRE FEEDER
M emory #4
Memory #5 Memory #6 Memory #1 -Weld P arameters -Mode -Preflow/P ostflow -Run in -St art Par ameters -Arc Control -Cra ter Parameters Memory #2 Memory #3 Procedure B -Weld Parameters -Mode -Preflow/Post flo w -Run in -Start Parameters -Arc Control -Crater P arameters -Burnb ack Proce dure A -Weld Parameters -Mode -Preflow/Post flow -Run in -Start Parameters -Arc Control -Crater P arameters -Burnb ack Procedure B -Weld Parameters -Mode -Preflow/Pos tfl ow -Run in -Start Parameters -Arc Control -Crater Parameters -Burnback Procedure A -Weld Parameters -Mode -Preflow/Pos tflo w -Run in -Start Parameters -Arc Control -Crater Parameters -Burnback Head / Procedure Select • Press to select head or change active procedure. • Changes to weld settings affect active procedure only. O l d b ti t Memory • Permanent storage for proc edure settings. • Six available memory locations. One procedure (A or B) can be stored in each. FIGURE B.4 HEAD 1 PROCEDURE HEAD 2 PROCEDURE A GUN GUN B A B M M PRESS AND HOLD TO SAVE MEMORY
M emory #4
Memory #5
Memory #6
Memory #1
-Weld Parameters
-Mode
-Preflow/Postflow
-Run in
-St art Par ameters
-Arc Control
-Cra ter Parameters
Memory #2
Memory #3
Procedure B
-Weld Parameters
-Mode
-Preflow/Post flo w
-Run in
-Start Parameters
-Arc Control
-Crater Parameters
-Burnb ack
Proce dure A
-Weld Parameters
-Mode
-Preflow/Post flow
-Run in
-Start Parameters
-Arc Control
-Crater Parameters
-Burnb ack
Procedure B
-Weld Parameters
-Mode
-Preflow/Pos tfl ow
-Run in
-Start Parameters
-Arc Control
-Crater Parameters
-Burnback
Procedure A
-Weld Parameters
-Mode
-Preflow/Pos tflo w
-Run in
-Start Parameters
-Arc Control
-Crater Parameters
-Burnback
Head / Procedure Select
•
Press to select head or change active
procedure.
•
Changes to weld settings affect
active procedure only.
O l
d b ti t
Memory
•
Permanent storage for procedure
settings.
•
Six available memory locations. One
procedure (A or B) can be stored in
each.
FIGURE B.4
HEAD 1
PROCEDURE
HEAD 2
PROCEDURE
A GUN GUN B A B
M M
PRESS AND HOLD TO SAVE
MEMORY