Lindy iSWITCH User Manual
Page 29
29
10. After rebooting the system, the new settings will be activated. Reboot (y/n)? Hit the y key then hit enter.
11. The iSwitch has rebooted to activate the new settings. Click OK. Arrow down to exit then hit enter.
12. At the MS-DOS Prompt type exit, then hit enter.
13. The Telnet Configuration is complete. The iSwitch is fully operational. After about thirty seconds the Link
LED will start blinking, now you can communicate with the iSwitch. The Ping command is supported at this
time. Startup a Browser and type in the IP Address. The default password is admin (lower case). Go to the
section in the User’s Manual titled “Web-Based Configuration” it will guide you through the Web pages.
14. All functions description please refer to Page 30.