Lindy iSWITCH - Manual (Page 30)

30
Web-Based Configuration
This section will guide you through the Web-Based-Configuration and the Web Pages of the Remote Power
Manager (iSwitch).
NOTE: You must complete the appropriate Setup Procedures before proceeding with the Web-Based-
Configuration.
The Ethernet cable is connected to the iSwitch and the iSwitch is on.
1. Startup a Web browser.
2. Type in your IP Address.
3. Next you will be asked for the User Name and Password. The default Name and Password is admin. Enter
the password, then hit enter. Then, in the browser left side will show up the option menu. You can configure
the iSwitch by selecting menu.
Server
Sys. Information Support MIB II to define the System Group
Network Set the network parameters, including IP address
etc.
PPP Configuration Set the information when controlled through
modem.
Date Set ePowerSwitch server date
Administrator 1. Set the administrator’s login name and
password.
2. Set the security level
API Configuration
(option) Provide Application Programming Interface
User Management Set the general users’ login name, password and
controllable outlet.
Software Upgrade 1. Indicate the firmware version.
2. Provide the upgrade interface by TFTP.
Save & Restart The procedure must be executed after change
some information
Client List all the devices cascading through RS485
iSwitch
Status Indicate the outlets status, turn on/off the outlets
Configuration Set the outlets’ functions.
Schedule Set the outlets controlled schedule.
Event Action Based on the pre-set action happened by iSwitch,
notify the user through every kind of ways.
Event Logging Record all the iSwitch events.