Lindy iSWITCH User Manual
Page 47
Advertising
47
16. Plug the third iSwitch's power cord into utility power.
17. Turn the master power switch on.
18. Configure the third iSwitch's ID number (each iSwitch must have it's own unique ID#, the default ID# is "0").
19. If there are only three RPMs required for this application, then this completes the Daisy Chaining procedure
and the RPMs are ready for use.
20. If your application requires additional RPMs (maximum of sixteen), then repeat steps 13-19 of the Daisy
Chaining procedure.
Advertising