Linear REMOTE ACCESS SOFTWARE DVS-1200 - Manual (Page 28)

26
4.10 COMMUNICATOR MAIN
PURPOSE:
For confi guring the Console’s communicator format, dialing method,
remote access password, dialing delay, and auto answer options.
USER RESPONSE:
COMMUNICATOR MAIN
✦ Check the ON box to enable the communicator in the Console.
☞ NOTE: You may want to turn the communicator off while testing the system
to prevent the Console from trying to dial out when it is not connected to
a telephone line.
✦ FORMAT: Select either 4 BY 2 or ADEMCO CONTACT ID for the communicator
format depending on the Central Station’s requirements.
✦ DIAL METHOD: Select either TONE or PULSE dialing for the Console.
✦ REMOTE ACCESS PASSWORD: Enter a six-digit password. This is the password
required to connect to the Console with the RA-2400 program. The default
password is “987654”. DO NOT FORGET THIS PASSWORD, LOCAL OR
REMOTE PROGRAMMING ACCESS TO THE DVS-2400 IS IMPOSSIBLE
WITHOUT IT.
✦ 30 SECOND DIALING DELAY: Check this box to cause a 30 second delay before
the communicator starts to dial after an alarm. This gives the subscriber time
to cancel a Central Station report before the unit dials out.
✦ SWINGER ELIMINATOR: Check this box to limit the maximum number of Central
Station burglary reports to fi ve per arming period. This will not effect the
24-hour zones (fi re, panic, and emergency).
✦ REMOTE LOCKOUT: Check this box to disable the Console’s telephone ring
detection feature. This keeps the Console from automatically answering the
phone. Even if this box is checked, the Console can still be programmed by
placing the Console into Test Mode and forcing the Console to answer by
pressing the EMERGENCY button while the phone is ringing.
217473 C - IMAGE 28