Link electronic MC-6 User Manual
Page 24
24
To Configure the Amplifier for Three Channel Use
To Configure the Amplifier for Three Channel Use
1.
11
Connect the left front channel interconnect from your pre-amp
or source component to the CHANNEL 1 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 1
BAL/UNBAL switch towards the connector that is being used.
22
Connect the right front channel interconnect from your pre-amp
or source component to the CHANNEL 6 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 6
BAL/UNBAL switch towards the connector that is being used.
33
Connect the center channel interconnect from your pre-amp or
source component to the CHANNEL 3 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 3
BAL/UNBAL switch towards the connector that is being used.
44
Flip the LINK INPUT 6 TO 5/UNLINK (NORMAL) switch “ON”, or up
towards LINK INPUT 6 TO 5. Flip the LINK INPUT 4 TO 3/UNLINK
(NORMAL) switch “ON”, or up towards LINK INPUT 4 TO 3. Flip the
LINK INPUT 2 TO 1/UNLINK (NORMAL) switch “ON”, or up towards
LINK INPUT 2 TO 1.
55
Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 1 to CHANNEL
2.
66
Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 3 to CHANNEL
4.
77
Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 5 to CHANNEL
6.
88
Connect your left front loudspeaker cable to the Channel 1
SPEAKER OUTPUT connector.
99
Connect your right front loudspeaker cable to the Channel 5
SPEAKER OUTPUT connector.
10
10
Connect your center channel loudspeaker cable to the Channel
3 SPEAKER OUTPUT connector.
The signal connections are now complete. Please recheck your
connections before operating the amplifier.