Link electronic MC-6 User Manual
Page 26
26
To Configure the Amplifier for Four
To Configure the Amplifier for Four--Channel Use
Channel Use
11
Connect the left channel 1 interconnect from your pre-amp or
source component to the CHANNEL 1 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 1
BAL/UNBAL switch towards the connector that is being used.
22
Connect the right channel 1 interconnect from your pre-amp or
source component to the CHANNEL 4 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 4
BAL/UNBAL switch towards the connector that is being used.
33
Connect the left channel 2 interconnect from your pre-amp or
source component to the CHANNEL 3 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 3
BAL/UNBAL switch towards the connector that is being used.
44
Connect the right channel 2 interconnect from your pre-amp or
source component to the CHANNEL 6 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 6
BAL/UNBAL switch towards the connector that is being used.
55
Flip the LINK INPUT 5 TO 4/UNLINK (NORMAL) switch “ON”, or up
towards LINK INPUT 5 TO 4. Flip the LINK INPUT 3 TO 2/UNLINK
(NORMAL) switch “ON”, or up towards LINK INPUT 3 TO 2.
66
Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 2 to CHANNEL
3.
77
Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 4 to CHANNEL
5.
88
Connect your left channel 1 loudspeaker cable to the Channel 1
SPEAKER OUTPUT connector.
99
Connect your right channel 1 loudspeaker cable to the Channel
5 SPEAKER OUTPUT connector.
10
10
Connect your left channel 2 loudspeaker cable to the Channel 3
SPEAKER OUTPUT connector.
11
11
Connect your right channel 2 loudspeaker cable to the Channel
6 SPEAKER OUTPUT connector.
The signal connections are now complete. Please recheck your
connections before operating the amplifier.