Link electronic MC-6 User Manual
Page 28
28
To Configure the Amplifier for Five
To Configure the Amplifier for Five--Channel Use
Channel Use
11
Connect the left front channel interconnect from your pre-amp
or source component to the CHANNEL 1 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 1
BAL/UNBAL switch towards the connector that is being used.
22
Connect the center channel interconnect from your pre-amp or
source component to the CHANNEL 2 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 2
BAL/UNBAL switch towards the connector that is being used.
33
Connect the left rear channel interconnect from your pre-amp or
source component to the CHANNEL 4 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 4
BAL/UNBAL switch towards the connector that is being used.
44
Connect the right rear channel interconnect from your pre-amp
or source component to the CHANNEL 5 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 5
BAL/UNBAL switch towards the connector that is being used.
55
Connect the right front channel interconnect from your pre-amp
or source component to the CHANNEL 6 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 6
BAL/UNBAL switch towards the connector that is being used.
66
Flip the LINK INPUT 3 TO 2/UNLINK (NORMAL) switch “ON”, or up
towards LINK INPUT 3 TO 2.
77
Using the output terminal linking cables of your choice (see page
14), connect the output binding posts of CHANNEL 2 to CHANNEL
3.
88
Connect your left front loudspeaker cable to the Channel 1
SPEAKER OUTPUT connector.
99
Connect your center channel loudspeaker cable to the Channel
3 SPEAKER OUTPUT connector.
10
10
Connect your left rear loudspeaker cable to the Channel 4
SPEAKER OUTPUT connector.
11
11
Connect your right rear loudspeaker cable to the Channel 5
SPEAKER OUTPUT connector.
12
12
Connect your right front loudspeaker cable to the Channel 6
SPEAKER OUTPUT connector.
The signal connections are now complete. Please recheck your
connections before operating the amplifier.