Link electronic MC-6 User Manual
Page 30
30
To Configure the Amplifier for Six
To Configure the Amplifier for Six--Channel Use
Channel Use
1.
11
Connect the left front channel interconnect from your pre-amp
or source component to the CHANNEL 1 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 1
BAL/UNBAL switch towards the connector that is being used.
22
Connect the right front channel interconnect from your pre-amp
or source component to the CHANNEL 6 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 6
BAL/UNBAL switch towards the connector that is being used.
33
Connect the left rear channel interconnect from your pre-amp or
source component to the CHANNEL 2 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 2
BAL/UNBAL switch towards the connector that is being used.
44
Connect the right rear channel interconnect from your pre-amp
or source component to the CHANNEL 5 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 5
BAL/UNBAL switch towards the connector that is being used.
55
Connect the center channel interconnect from your pre-amp or
source component to the CHANNEL 3 balanced XLR or
unbalanced RCA input connector. Select the correct balanced
or unbalanced input connector by flipping the Channel 3
BAL/UNBAL switch towards the connector that is being used.
66
Connect the passive subwoofer channel interconnect from your
pre-amp or source component to the CHANNEL 4 balanced XLR
or unbalanced RCA input connector. Select the correct
balanced or unbalanced input connector by flipping the
Channel 4 BAL/UNBAL switch towards the connector that is being
used.
77
Verify that all of the LINK INPUT switches are in the “OFF” position,
or down towards the UNLINK (NORMAL) position.
88
Connect your left front loudspeaker cable to the Channel 1
SPEAKER OUTPUT connector.
99
Connect your right front loudspeaker cable to the Channel 6
SPEAKER OUTPUT connector.
10
10
Connect your left rear loudspeaker cable to the Channel 2
SPEAKER OUTPUT connector.
11
11
Connect your right rear loudspeaker cable to the Channel 5
SPEAKER OUTPUT connector.
12
12
Connect your center channel loudspeaker cable to the Channel
3 SPEAKER OUTPUT connector.
13
13
Connect your passive subwoofer loudspeaker cable to the
Channel 4 SPEAKER OUTPUT connector.
The signal connections are now complete. Please recheck your
connections before operating the amplifier.