LevelOne FBR-1700TX - Manual (Page 15)

Introduction
11
Components - FBR-1401TX
Figure 4: Rear Panel - FBR-1401TX
Reset Button This button has three (3) functions:
• Reboot. When pressed and released, the LevelOne Broadband
Router will reboot (restart).
• Diagnostic print-out. If held down for 3 seconds, a diagnostic
print-out will be sent to the attached printer.
• Ensure the printer is ready.
• Both Print LEDs will flash simultaneously during the diag-
nostic printing.
• Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The LevelOne Broadband Router is
now using the factory default values.
WAN port
(10BaseT) Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
10/100Bas eT
LAN connections Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note:
Any LAN port on the LevelOne Broadband Router will automatically
function as an "Uplink" port when required. Just connect any port to
a normal port on the other hub, using a standard LAN cable.
Power port (12V) Connect the supplied power adapter here.
Printer Port Standard parallel printer port. If you wish to share a printer, connect it
here.