LevelOne FBR-1700TX - Manual (Page 18)

LevelOne Broadband Router User Guide
14
DIP Switches
DIP Switch Setting Description
1=off
2=off Normal Operation.
1=off
2=on DHCP Server function disabled.
1=on
2=off Used to restore Default IP Address
and clear Password (See below).
1=on
2=on Normal Operation.
Restore Default IP Address and Clear Password
If the LevelOne Broadband Router's IP Address or password is lost, the following procedure
can be used to recover from this situation.
1. Turn the power to the LevelOne Broadband Router OFF.
2. Set DIP switch 1 ON.
3. Turn the power to the LevelOne Broadband Router ON.
4. Operate DIP switch 1 in the following sequence (you have 15 seconds to complete the
sequence):
• OFF
• ON
• OFF
5. The LevelOne Broadband Router will now reset, and the Red Status LED flash. The follow-
ing changes will have been made. (Other configuration data is unchanged.)
• IP Address set to its default value of 192.168.0.1
• Network Mask set to 255.255.255.0
• DHCP Server is enabled, and will allocate IP Addresses in the range 192.168.0.2 to
192.168.0.51.
• The password cleared (no password).
6. You can now connect to the LevelOne Broadband Router and make any configuration
changes required
.