Lexmark 410 User Manual
Page 57
•
Flex a stack of envelopes back and forth to loosen them, and then fan them. Straighten the edges on a level
surface.
4
Load the media stack with the recommended print side facedown and the top edge entering the printer first.
Note: Load only one size and type of media at a time.
5
Load envelopes with the flap side up and the return address edge entering the printer first.
Warning—Potential Damage: Never use envelopes with stamps, clasps, snaps, windows, coated linings, or
self
‑stick adhesives. These envelopes may severely damage the printer.
6
Make sure the media is as far into the multipurpose feeder as it will go with very gentle pushing. Media should lie
flat and fit loosely in the multipurpose feeder.
Note: If the media is pushed too far into the multipurpose feeder, you must press the paper release lever to
remove it.
7
From the printer control panel, set the Paper Size and Paper Type, and then press
.
The multipurpose feeder can be closed when not in use.
Loading paper and specialty media
57