29 pc-setting – Lenco Marine PL 4201 User Manual
Page 29
29
PC-Setting
In general, a vacuum tube monitor is equipped for your PC. Before you connect this PDP-Monitor to your
PC, change the adjustment of your PC's graphic card. Otherwise any picture will not appear on the PDP-
Monitor. Turn on your PC (still with your old Monitor) and select under 1280 x 768 for on-screen graphic
resolution. Select under 60 Hz for on-screen refresh rate. Turn off your PC and connect the turned off
Plasma-TV.
VGA Cable
(not supplied)
Use the optional PC-VGA cable (not supplied) to connect the
PDP-Monitor with your PC. Plug the cable carefully not to
break or bend the contact inside of plug.
See next page for PC Monitor Menu.
2 +
Select PC input
Turn on the Plasma-TV again.
Press 0/AV repeatedly until “PC” appears on the TV screen.
Note:
If there is no video signal from the computer when the unit is in
PC mode, “No Signal” will appear on the TV-screen for approx.
10 seconds.
Note:
The PC Monitor Menu settings are not
effective for normal TV-mode or
external input mode.
?
3U84011A [E] P26-34
20/12/05, 15:22
29