Lanier LD230 - Manual (Page 39)

Turning On the Power
27
1
Saving Energy
-Energy Saver Mode
If you do not use the machine for a
certain period after an operation, or
when you press the {Energy Saver}
key, the display disappears and the
machine goes into Energy Saver
mode. When you press the {Energy
Saver}
key again, the machine returns
to the ready condition. The machine
uses less electricity in Energy Saver
mode.
Note
❒ You can change the amount of time
the machine waits before switch-
ing to Energy Saver mode after
copying has finished or the last op-
eration is performed. See p.60
“Panel Off Timer”.
-Auto Off
The machine automatically turns it-
self off when the job is finished, after
a certain period of time has elapsed.
This function is called "Auto Off".
Note
❒ You can change the Auto Off time.
See p.59 “Auto Off Timer”.
❒ The Auto Off Timer function will
not operate in the following cases:
• When a warning message ap-
pears
• When the service call message
appears
• When paper is jammed
• When the cover is open
• When the "
Add Toner " message
appears
• When toner is being replenished
• When the User Tools/Counter
screen is displayed
• When fixed warm-up is in progress
• When the facsimile, printer, or
other functions are active
• When operations were sus-
pended during printing
• When the handset is in use
• When the On-hook dialing
function is in use
• When a recipient is being regis-
tered in the address list or
group dial list
• When the Data In indicator is on
or blinking
• When the screen of stored docu-
ment under the printer function
is displayed