Loewe Individual Sound Projector - Manual (Page 17)

17 -
Auto set-up (TV sets without RS-232C
System Interface)
➠ Make sure that the devices are set up correctly (page 8/9), all connections
have been made properly (page 11,13) and that the microphone is connected
and set up correctly (page 14).
Settings on TV set
On your TV set, (with Loewe TV sets in the "Connection wizard"), set the audio
output to HiFi/AV amplifier.
Setting user interface language
Set the remote control up for TV operation.
Press the on/off button on the remote control to switch on the
Loewe TV set.
Call up AV selection.
34 Select the AV programme position that the Sound
Projector is connected to.
Confirm OK.
Set the remote control up for Sound Projector operation.
Press the on/off button on the remote control to switch on the
Sound Projector.
Press the button for a long time.
The menu LANGUAGE SETUP appears.
ENGLISH
DEUTSCH
Francais
ESPANOL
ITALIANO
NEDERLANDS
[] / [] : Up / Down

[OK] : Enter
LANGUAGE SETUP
56 Select required language.
Confirm OK.
The language selected is also shown on the display of the
Sound Projector (display always in English).
Starting auto set-up
Press the button for a long time.
The menu AUTO SETUP appears.
PREPARATION & CHECK
Please connect the MIC.
Please place the MIC at least
1.8m/6ft away from the SP
unit. The MIC should be set
at ear level when seated.
Measurement takes about 3min.
After [OK] is pressed,
please leave the room.
[OK] : Start
[END] : Cancel
AUTO SETUP
OK Start auto set-up.
Will begin in 10sec
 ──────
[END] : Cancel
AUTO SETUP
➠ During auto set-up the listening room should be free of noise interference.
Please leave the room during this time so that the sound beams can spread
without disturbance.
➠ If an error occurs during auto set-up, a warning will sound and a message
will appear on the TV screen (page 6). If necessary, check the above described
conditions for the Sound Projector to work perfectly.
➠ Autoset-up takes about 3 minutes and a final chime sounds when it
finishes.
➠ You can save three listening positions and call them up again, for example,
to be able to take changing conditions in the listening room into consideration.
➠ Position the microphone at least 1.8 m away from the Sound Projector cen-
tred on it on a level surface.
Initial set-up