Loewe Individual Sound Projector - Manual (Page 26)

- 6
Troubleshooting
Error Message Possible cause Remedy
ERROR E-1 Your listening room has too much unwanted noise. Ensure that it is as quiet as possible in your listening room. We recommend
choosing a time of day when there is less noise outside.
ERROR E- The optimisation microphone was disconnected during auto set-up . Ensure that the optimisation microphone is firmly connected to the unit
(page 14).
ERROR E-3 During auto set-up other operating processes were run on this unit. During auto set-up do not carry out any other
operating processes.
ERROR E-4 The optimisation microphone is not in front of this unit. Ensure that the optimisation microphone is positioned in front of this unit.
ERROR E-5 The optimisation microphone is not positioned at the right distance from
this unit. Ensure that the optimisation microphone is more than 1.8 m from the front
of the unit and is within 1 m of the average height of the unit.
ERROR E-6 The optimisation microphone can not receive the noise produced by this
unit because the noise output level is too low. Ensure that the optimisation microphone is firmly connected to this
unit and has been set up properly. If the problem persists, contact your
Loewe dealer.
ERROR E-7 An internal system error has occurred. Repeat auto set-up.
ERROR E-8 The measurement did not end at the expected time
and was cancelled. Repeat auto set-up.
ERROR E-9 Cancelled by user Repeat auto set-up.
Special functions
The Sound Projector has got additional setting options which are only intended for specialist staff.
Press button for a long time. The menu SETTINGS appears.
➠ Unless you have sufficient expertise, do not make any changes to the settings in this area, as this may maladjust the unit to the extent that it no longer works
properly afterwards.
Press the button for a long time to close the menu.
Error messages for auto set-up