Loewe Individual Sound Projector - Manual (Page 19)

19 -
Playback
Selecting signal
You can play backsound from connected devices.
Press AUX (PIP) on the remote control several times
or on the unit press SOURCE several times to select the
required signal source.
The name of the selected input signal source and the type of corresponding input
mode are shown on the Sound Projector display.
Switch sound on/off
Sound off;
Sound on: Press button again or adjust volume V+.
Adjusting volume
V+/V– volume up / down
or on the unit press Vol -/Vol + .
The volume bar is shown briefly if no other menu is displayed.
Other sound settings for TV sets with RS-232C System
Interface
➠ As long as the volume bar or the selection of loudspeakers can still be seen
in listening mode.
5 Call up additional sound settings.
34 Select sound settings.
6 Change to the menu line below.
34 Make changes.
➠ You can also make additional sound settings on Loewe TV sets under the
TV menu – Sound.
Loading listening position
You can call upthe listening position that you saved previously (page 15, 18).
TV sets with RS-232C system interface
➠ No further menu is shown.
34 Select.
Listening position ...
Position 2 (MEM2) Position 1 (MEM1) Position 3 (MEM3)
34 Select one of the memory positions Position 1-3
(MEM1-3) .
Confirm OK.
TV sets with an RS-232C system interface and swivel
caster control
➠ No further menu is shown.
34 Select.
Rotate TV (MEM2)
-20
34 Select one of the memory positions Position 1-3
(MEM1-3). These are marked on the bar.
Confirm OK.
Everyday use