Lennox Hearth 8560 - Manual (Page 22)

Getting Started
Page 8 Mitel ® Model 8560/8660 User Guide – Issue 12, October 2008
Headset Instructions
When using a headset, press (Speaker) to connect to or disconnect from calls.
If you have both a headset and a handset connected to your endpoint and you are using the
headset, you can quickly transfer audio to the handset by lifting the handset from the cradle.
Press to transfer the call back to the headset before replacing the handset in the cradle.
To connect and activate the headset:
1. Insert the headset jack into the Headset port located on the back of the endpoint. See
“Endpoint Connectors” on page 6 .
2. Dial 317 to turn the headset on. HEADSET MODE ON appears.
To turn off Headset Mode and activate the handset and speakerphone:
Dial 317. HEADSET MODE OFF appears. The handset or speakerphone is now
activated.
NOTES
The headset must be HAC.
If your headset has a power-saver mode, make sure the system administrator has
enabled the “Headset Connect Tone” feature. If this is not enabled, you may miss
the first few seconds of an incoming call.