Lennox Hearth 8560 - Manual (Page 8)

Page iv Mitel ® Model 8560/8660 User Guide – Issue 12, October 2008
Endpoint Usage
This equipment is not for connection to the telephone network or public coin phone service. It is only for use when
connected to Mitel systems.
WARNING
When using your endpoint equipment, basic safety precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons, including the following:
• Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub,
in a wet basement, or near a swimming pool.
• Avoid using an endpoint (other than a cordless type) during an electrical storm. There may be a remote
risk of electric shock from lightning.
• Do not use the endpoint to report a gas leak in the vicinity of a leak.
• Do not connect directly to the Public Switched Telephone Network (PSTN). Any connection of this
endpoint to an off premise application, an out of plant application, any other exposed plant application,
or to any equipment other than the intended application may result in a safety hazard, and/or defective
operation, and/or equipment damage. “Exposed plant” means where any portion of the circuit is subject
to accidental contact with electric lighting or power conductors operating at a voltage exceeding 300
volts between conductors or is subject to lightning strikes.
• The socket outlet, if used, shall be located near the equipment and shall be easily located by the user.
• Use only Mitel approved power adaptors. See “Power Requirements” on page iii .
• The handset supplied with the endpoint is not certified for use with any other phone. Use of the handset
with any other phone may have the potential to cause hearing loss in the event of a lighting strike on the
outside plant wiring.