Lexmark 302 - Manual (Page 269)

setup, printer (continued)
F1 (Continuous Forms Device)
(continued)
prepare to load F1
forms 1-21
print verification test for the F1
forms device 1-30
F2 (Dual Purpose Forms Device)
check out F2 forms device
installation 1-55
install the 1-53
load forms in the F2 forms
device 1-57
prepare to load F2
forms 1-56
print verification test for the F2
forms device 1-63
F3 (Document Insertion Device)
check out F3 forms device
installation 1-87
install the 1-85
load forms in the F3 forms
device 1-91
prepare to load F3
forms 1-90
print verification test for the F3
forms device 1-95
install the ribbon cartridge 1-6
introduction 1-1
parts checklist
1-2
prepare for installation
forms device 1-12
ribbon cartridge 1-6
printer problems 1-13
ribbon guide installation 1-8
side frames 2-20
six-part forms, using 2-15
starting a print job 2-22
states of operation 2-14
status codes and message
displays B-2
stopping a print job 2-23
T
tear bar 2-17, A-4
tension, tractor adjustment 1-37,
1-68
Tests, Operator Print 4-1
top of form position adjustment
F1 (Continuous Forms
Device) 1-44
F2 (Dual Purpose Forms
Device) 1-74
F3 (Document Insertion
Device) 1-104
tractor tension, adjustment 1-37,
1-68
training guideline A-1
U
Unit Check indicator 2-12
unloading forms
F1 (Continuous Forms
Device) 1-49
F2 (Dual Purpose Forms
Device) 1-81
F3 (Document Insertion
Device) 1-110
unloading forms, warning B-27
using your printer xix
Index X-13