Linksys BEFSR41 v2 EN - Manual (Page 13)

3. Connect the network cable from your cable or DSL modem to the WAN
port on your Router’s rear panel. This is the only port that will work for your
modem connection.
4. Connect the power adapter to the Power port on the rear panel of the
Router, then plug the power adapter into a power outlet.
• The Power LED on the front panel will light up green as soon as the power
adapter is connected properly.
• The Diag LED will light up red for a few seconds when the Router goes
through its self-diagnostic test. This LED will turn off when the self-test
is complete.
5. Power on the cable or DSL modem.
6. Press the Reset button on the Router’s front panel with a paper clip or a
pencil. Hold the button in until the Diag LED lights up and then turns off.
This will restore the Router’s factory default settings.
The Router’s hardware installation is now complete!
Continue with the next section to configure
the Router with your PCs.
Technical Checkpoint:
Did you remember to check for Link LEDs for all your connections?
If all of your Link LEDs are not lighting up, make sure that all your
cables are securely plugged in, and that all of your hardware is powered
on properly.
EtherFast Cable/DSL Routers
Uplinking: Connecting More Devices to Your Router
If your Router’s LAN ports are all full and you still have PCs and/or devices
to connect, connect a hub or a switch to your Router.
To do so, use the Router’s Uplink port to connect to a standard port on a hub
or switch. If you have a PC/device connected to the port right next to the
Uplink port (on the 3- and 4-Port Routers), disconnect that PC/device and
plug it into an open port on the new hub or switch.
Since the Uplink port shares internal wiring with the port right next to it, you
can only use only one of these two ports at a time: these ports are called
shared ports.
If your new hub or switch also has an Uplink port, it too can be uplinked
when you next run out of ports, and so on.
Use the Router’s Uplink port to connect to a standard port on a hub or
switch. This leaves you with new, open ports on the hub or switch, to which
you can add more PCs and/or network devices.
See your nearest Linksys retailer or visit www.linksys.com for complete
product lines of 10/100 Mbps hubs and switches.
20
Instant Broadband Series
19
N No otte e:: It is highly recommended that you plug your
Router into a power strip with surge protection.