Linksys BEFSR41 v2 EN - Manual (Page 29)

EtherFast Cable/DSL Routers
52
Instant Broadband Series
51
DMZ Hosting
The DMZ Hosting feature allows one local user to be exposed to the Internet
to use a special-purpose service such as Internet gaming and video-conferenc-
ing.
Whereas IP Forwarding can only forward a maximum of 10 ranges of ports,
DMZ hosting forwards all the ports for one PC simultaneously.
• To expose one PC, enter the computer’s IP address and click the Apply but-
ton.
• Deactivate DMZ by entering a zero (0) in the field and clicking the Apply
button.
1. Select Static Route Entry from the drop-down list. The Cable/DSL Router
supports up to 20 static route entries.
2. Enter the following data to create a static route:
Destination LAN IP The Destination LAN IP address is the Address of the
remote network or host to which you want to assign a static route. Enter the
IP address of the host for which you wish to create a static route here. If
you are establishing a route to an entire network, be sure that the network
portion of the IP address is set to zero (0).
For example, the Router’s standard IP address is 192.168.1.1. Based on this
address, the address of the network to which the Router is connected is
192.168.1, with the last digit (1, in this case) determining the Router’s place
on the network. Therefore, you would enter the IP address 192.168.1.0 if
you wanted to route to the Router’s entire network, rather than to just the
Router.
Subnet Mask The Subnet Mask (also called the Network Mask) deter-
mines which portion of an IP address is the network portion and which por-
tion is the host portion. In the example above, the Network Mask is
255.255.255.0. This determines (by using the values 255) that the first
three numbers of an network IP address identify this particular network,
while the last digit (from 1 to 254) would identify the specific host.
Default Gateway This IP address must be the IP address of the gateway
device that allows for contact between the Router and the remote network
or host.
Hop Count This value gives the number of nodes that a data packet passes
through before reaching its destination. A node is any device
on the network, such as switches, PCs, etc.
Interface Interface tells you whether your network is on the LAN or the
WAN, or the Internet. If you’re connecting to a sub- network, select LAN.
If you’re connecting to another network through the Internet, select WAN.
3. Click the Apply button to save your changes.