Linksys BEFSR41 v2 EN - Manual (Page 18)

EtherFast Cable/DSL Routers
30
Instant Broadband Series
29
USB Configuration for Windows Millennium
1. With the router connected to your PC’s USB port, start up your PC in
Windows Millennium and insert your driver diskette.
2. Windows will notify you that new hardware has been detected (shown
above). Select “Automatic search for a better drive (Recommended)” and
click the Next button.
3. Windows will display a message saying that it has finished installing the
driver files on your PC. Click the Finish button.
5. When your PC is finished restarting, click the Start button, select Settings,
Control Panel, and Network. Make sure that TCP/IP is installed for your
PC as shown on the screen below. If TCP/IP is not installed, please go to the
Installing the TCP/IP Protocol section in the Appendix for instructions on
installation.
Your USB installation is now complete.
Continue on to the next page to configure
your network to work with the Router.
4. Windows will ask you to restart your PC. Click the Yes button.