Linksys BEFSR41 v2 EN - Manual (Page 27)

EtherFast Cable/DSL Routers
To add a server using Forwarding:
1. Enter the port number or range of ports used by the server. On the same
line, select the protocol UDP, TCP, or Both, and enter the LAN IP address
of the server that you want the Internet user(s) to access.
2. Configure as many entries as needed—the Router supports up to 10 ranges
of ports. Click the Apply button when you’re done.
Using Port Triggering
Port triggering allows the Router to watch outgoing data for specific port num-
bers. The IP address of the computer that sends the matching data is remem-
bered by the Router, so that when the requested data returns through the fire-
wall, the data is pulled back to the proper computer by way of IP address and
port mapping rules.
1. Enter the application name of the trigger.
2. Enter the port range used by the application.
3. Enter the incoming port range used by the application.
4. Click the Apply button to continue.
48
Instant Broadband Series
47
• To disable this feature, click on Disable, then click the Apply button.
Using Remote Upgrade
• This feature allows you to upgrade your Router’s firmware from a remote
location. To enable Remote Upgrade, click on Enable, then click on the
Apply button. Remote Management must be activated before you leave to a
remote location.
Using MTU (Maximum Transmission Unit)
• This feature allows for the transmission of the largest packet size over the
network. Select Enable and enter the value desired. It is recommended that
you leave this value at the 1200 to 1500 range. For most DSL users, it is rec-
ommended to use 1492. By default, MTU is set at 1500 when disabled.
Forwarding sets up public services on your network, such as web servers, ftp
servers, or email servers. When users send this type of request to your net-
work via the Internet, the Router will forward those requests to the appropri-
ate PC. Before using Forwarding, the Router's DHCP function must be dis-
abled under the DHCP tab and the Router must be assigned a new static LAN
IP address because the IP address may change when using the DHCP server.
IP Forwarding