Linksys BEFSR41 v2 EN - Manual (Page 19)

EtherFast Cable/DSL Routers
32
Instant Broadband Series
31
4. Click the Properties button, then choose the IP Address tab. Select Obtain
an IP address automatically. Click the OK button.
You have now completed the PC’s client settings, so it can connect to the
Router.
5. Click the OK button. Windows may ask for original Windows installation
files. Direct your PC to the location of the files, e.g., D:\win98,
D:\win9x, D:\win95 , or c:\windows\options\cabs .
6. Windows will ask you to restart the PC. Click the Yes button.
7. Repeat these steps for each PC on your network.
When all of your PCs are configured,
the TCP/IP setup and configuration are complete.
Continue on to the next section
to complete your network setup.
Configuring Your Network with the
Cable/DSL Router
Configuring PCs to Connect to the Cable/DSL Router
Now you may have to configure your other PCs to accept the IP addresses that
your Router will provide. If you have not set a static IP or dynamic IP address,
please follow the directions below. Otherwise, skip to the next section titled
Configuring Your Cable/DSL Router.
1. Click the Start button, select Settings, then Control Panel.
2. Double-click on the Network icon.
3. In the Configuration window, select the TCP/IP protocol line associated
with your network card/adapter. If there is no TCP/IP protocol line listed for
your card/adapter, go to the Installing the TCP/IP Protocol section in the
Appendix to install the TCP/IP protocol now.
N No otte e:: Make sure that a network card or adapter has been successfully
installed in each PC you plan on configuring before continuing.
N No otte e:: These instructions apply only to Windows 95, Windows
98, and Windows ME machines. For TCP/IP setup under
Windows NT or 2000, see your Windows manual.