Linksys CISCO WRT610N - Manual (Page 31)

Chapter 3
Advanced Configuration
29 Simultaneous Dual-N Band Wireless Router
Administration > Management
The Administration > Management screen allows the
network’s administrator to manage specific Router
functions for access and security.
Administration > Management
Router Password
Router Access
Router Password Enter a new Password for the Router.
Re-enter to confirm Enter the Password again to confirm.
Local Management Access
Access via HTTP (HyperText Transport Protocol) is the
communications protocol used to connect to servers on
the World Wide Web. HTTPS uses SSL (Secured Socket
Layer) to encrypt data transmitted for higher security.
Select the HTTP or HTTPS check box. The default selection
is HTTP.
Access via Wireless If you are using the Router in a public
domain where you are giving wireless access to your guests,
you can disable wireless access to the Router’s web-based
utility. You will only be able to access the web-based utility
via a wired connection if you disable the setting. Keep the
default, Enabled, to enable wireless access to the Router’s
web-based utility, or select Disabled to disable wireless
access to the utility.
Remote Management Access
Remote Management To access the Router remotely
from the Internet, select Enabled.
Access via Select HTTP or HTTPS communications
protocols for remote access from the Internet.
Remote Upgrade Select Enabled to be able to upgrade
the firmware remotely from the Internet.
Allowed Remote IP Address Select Any IP Address or
manually enter an Internet IP address to allow remote
access to the web-based utility from the Internet.
Remote Management Port Enter the port number that
will provide outside access to the Router’s web-based
utility. You will need to enter the Router’s password when
accessing the Router this way, as usual.
UPnP
UPnP Keep the default, Enabled, to enable the UPnP
feature; otherwise, select Disabled.
Allow Users to Configure To use the Allow Users to
Configure UPnP options from the Windows operating
system, select Enabled.
Allow Users to Disabled Internet Access To use the
Allow Users to Disabled Internet Access options from the
Windows operating system, click Disabled.
Backup and Restore
Backup Configurations To back up the Router’s
configuration file, click this button. Then, follow the on-
screen instructions.
Restore Configurations To restore the Router’s
configuration file, click this button. Then, follow the on-
screen instructions.
Click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes.
Administration > Log
The Router can keep logs of all traffic for your Internet
connection.
Administration > Log
Log
Log To disable the Log function, keep the default setting,
Disabled. To monitor traffic between the network and the
Internet, select Enabled.
Logviewer IP Address If your computer uses Logviewer
software you can enter enter the fixed IP address of the PC
running the software in the Logviewer IP Address field.s
The Router will now send updated logs to that PC.