Line 6 AXSys 212 - Manual (Page 17)

The Guided Tour: Chapter 2
AxSys 212 User Manual 17
To Store an Edited Sound into a different Sound location:
1 Press
STORE SOUND
, and the display will begin to flash:
U32
The Sound Bank and Sound will be identical to the last Sound selected.
2 Use the SOUND BANK
▲
/
SOUND BANK
▼ buttons to select any User Sound Bank
from 01 to 32.
3 Press either
SOUND
A
,
SOUND
B
,
SOUND
C
, or
SOUND
D
to select a
Sound location.
4 Press
STORE SOUND
again to complete the operation.
The display will briefly read
Std...to indicate the Sound has been stored.
If you decide you donÕt want to store the edited Sound after all, press any Edit
Row Select button to cancel out of the Store operation before storing.
Foot Pedals
There are three footpedal connectors on the back panel of the AxSys 212,
labeled
PEDAL (REMOTE) , PEDAL 1 (VOLUME) and PEDAL 2 (WAH) . PEDAL
(REMOTE) is designed for use with the optional AxSys pedal board. PEDAL
1
is for volume pedal, and
PEDAL 2
is for Wah-Wah.
If the VOLUME PEDAL ON/OFF parameter is set to
OFF,
PEDAL 1 pedal wonÕt
function; likewise, if the WAH PEDAL TYPE parameter is not set to
1 or 5,
PEDAL
2 wonÕt function.
If youÕve got only one pedal, make sure to plug it into the
PEDAL 1
jack.
Normally this jack is for volume (when the VOLUME PEDAL ON/OFF
parameter is turned on); but if the WAH PEDAL TYPE parameter is set to
1
or
5, the pedal will automatically switch to Wah-Wah. This means if you
only have one pedal, you donÕt have to switch jacks when you want to go
from a volume pedal to a Wah pedal. Cool, huh?
The WAH PEDAL TYPE parameter picks the type of Wah. When set to
1, the
Wah pedal is used to control the Wah effect. However, the WAH PEDAL
TYPE parameter can also be set to
5 (Mod Assign), which lets you control
other parameters, one at a time, from the
PEDAL 2 (WAH)
jack. For