Lantronix TSC 4092A IRIG-B - Manual (Page 13)

4092A Operations and Maintenance Manual 9
2.5 Setting the 4092A to Autoswitch Mode
As long as the 4092A is in autoswitch mode and has two input signals connected, the unit will
automatically switch to the other input channel if it stops receiving a signal on the active channel.
You can set the 4092A to autoswitch mode using either the switch on the front panel or remotely
using the Ethernet connection.
To set the 4092A to autoswitch mode from the front panel:
„ Move the toggle switch to the center position.
To set the 4092A to autoswitch mode remotely:
Note
The toggle switch on the front panel must be in the center position for this command to work
properly.
1. Telnet to the 4092A’s IP address.
„ No prompt displays in the Telnet window.
2. Type: C
2.6 Cleaning
Warning
Do not spray or use too much liquid when cleaning the unit. Liquid can enter the unit and damage
sensitive electronic components.
„ Clean the main chassis with a soft cloth dampened with a mild soap and water solution.