Lucent Technologies M770 - Manual (Page 29)

Cajun M770 ATM Switch Manager User’s Guide 19
Chapter 4
Fault Management
Fault management consists of the following:
• Configuring Traps - Defining the types of traps that are sent to the managers and
the event log.
• Viewing Traps - Viewing the traps sent by the agent.
In UNIX:
• Severity Degrees - Defining, accessing and understanding severity degrees.
Configuring Traps
A trap is an SNMP message sent by the agent to its managers. Trap messages may
appear in the affected port configuration windows of the management stations listed in
the Managers Table. You can set the types of traps that the agent forwards to the
management station which you are configuring.
To configure traps:
1 Open the Configuration menu and select Traps . The Traps Configuration dialog box
appears.
Figure 4.1 Traps Configuration Dialog Box
2 Select the check boxes for the types of traps that you want the agent to forward to
the management station that you are configuring.
3 Click Apply .
For a full description of the traps in the Traps Configuration dialog box, refer to
Appendix D, Trap Fields.