Lucent Technologies M770 - Manual (Page 30)

Chapter 4 Fault Management
20 Cajun M770 ATM Switch Manager User’s Guide
Viewing Traps
Traps that are sent by the agent to its managers may be viewed in two places:
• In the Port Configuration dialog box.
• In the Event Log.
Viewing Traps in a Dialog Box
A list of traps sent by the agent is maintained by the management application. The list
can be viewed in a dropdown list box in the Port Configuration dialog box of the
appropriate port.
Viewing Traps in the Event Log
HP OpenView maintains a list of all traps sent by the agents on the network. They may
be viewed by opening the Event Log from the HP OpenView network map window.
For a full description of the Event Log, refer to the HP OpenView Administrator’s Guide.
Assigning Severity Degrees in UNIX
Management applications, using the Event Configuration application, allow you to set
fault severity degrees system-wide, (for all hubs on the network simultaneously), or for
specific hubs (per IP). If the system-wide setting and an individual hub's setting
disagree, the individual hub's setting takes precedence.
For more information refer to Severity Degrees in The Reference Guide.
Accessing Severity Degrees
Only events whose category is “Status Events” affect the device’s status. Events in this
category may be found under the enterprises Lannet (.1.3.6.1.4.1.81) and CajunM770
(.1.3.6.1.4.1.81.17.1.15).
Severity degree settings may be accessed from the Event Configuration application. To
open the Event Configuration application:
1 From the umbrella management application, open the Tools menu and select
Lucent


Event Configuration .
OR
Open the Options menu and select Event Configuration .The Event Configuration
application appears.