Lanner electronic FW-7890 - Manual (Page 35)

Master detailed
options
IDE Channel 0 Slave Options are in its sub menu
Press <Enter> to enter the sub menu of
detailed options
IDE Channel 1
Master
Options are in its sub menu
Press <Enter> to enter the sub menu of
detailed options
IDE Channel 2
Master
Options are in its sub menu
Press <Enter> to enter the sub menu of
detailed options
Halt On
All Errors
No Errors
All, but Keyboard
All, but Diskette
All, but Disk/Key
Select the situation in which you want the
BIOS to stop the POST process and notify
you
Base Memory N/A
Displays the amount of conventional
memory detected during boot up
Extended Memory
N/A
Displays the amount of extended memory
detected during boot up
Total Memory
N/A
Displays the total memory available in the
system
IDE Adapters
The IDE adapters control the hard disk drive. Use a separate sub menu to configure each
hard disk drive.
IDE Primary Master sub menu
Use the legend keys to navigate through this menu and exit to the main menu. Use Table 1
to configure the hard disk.
Item Options Description
IDE HDD
Auto-detection
Press Enter
Press Enter to auto-detect the HDD on this channel. If
detection is successful, it fills the remaining fields on this
menu.
IDE Channel 0
Master
None
Auto
Manual
Selecting ‘manual’ lets you set the remaining fields on this
screen. Selects the type of fixed disk. "User Type" will let
you select the number of cylinders, heads, etc. Note:
PRECOMP=65535 means NONE !
Capacity
Auto Display
your disk drive
size
Disk drive capacity (Approximated). Note that this size is
usually slightly greater than the size of a formatted disk
given by a disk checking program.