Lanner electronic FW-7890 - Manual (Page 46)

3.10 Load Optimized Defaults
When you press <Enter> on this item you get a confirmation dialog box with a message similar
to:
L o a d O p t i m i z e d D e f a u l t s ( Y / N ) ? N
3.11 Supervisor/User Password Setting
You can set either supervisor or user password, or both of then. The differences between are:
Supervisor password: can enter and change the options of the setup menus.
User password: just can only enter but do not have the right to change the options of the
setup menus. When you select this function, the following message will appear at the center of
the screen to assist you in creating a password.
E N T E R P A S S W O R D :
Type the password, up to eight characters in length, and press <Enter>. The password
typed now will clear any previously entered password from CMOS memory. You will be
asked to confirm the password. Type the password again and press <Enter>. You may also
press <Esc> to abort the selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter the password.
A message will confirm the password will be disabled. Once the password is disabled, the
system will boot and you can enter Setup freely.
PASSWORD DISABLED :
When a password has been enabled, you will be prompted to enter it every time you try to enter
Setup. This prevents an unauthorized person from changing any part of your system configuration.
Additionally, when a password is enabled, you can also require the BIOS to request a password
every time your system is rebooted. This would prevent unauthorized use of your computer.
You determine when the password is required within the BIOS Features Setup Menu and its
Security option (see Section 3). If the Security option is set to “System”, the password will be
required both at boot and at entry to Setup. If set to “Setup”, prompting only occurs when
trying to enter Setup.