Panasonic DIGA DMR-E75V - Manual (Page 59)

Advanced Operations
59
[RAM] [DVD-R]
You can specify the position to start dubbing the programme
recorded on the tape to the disc.
≥The available discs for dubbing from the tape are DVD-RAM and
non-finalized DVD-R.
≥Copy-guarded video tapes cannot be dubbed. Most of
commercially sold/purchased video tapes are copy-guarded to
prevent illegal reproduction and they cannot be recorded with the
following procedure.
Preparation
VHS (Recording source)
≥Insert the video cassette containing the programme to be copied.
( l 50)
DVD (Recording target)
≥Release protection. (disc
l 28, cartridge l 15) [RAM]
≥Insert a disc and confirm there is sufficient empty space for
recording on it. ( l 17, 49)
Settings (“TV System” l 45)
≥When dubbing an NTSC tape to the DVD
- Set “TV System” on “Connection” in “SETUP” to “NTSC”.
≥When dubbing a PAL/MESECAM tape to the DVD
- Set “TV System” on “Connection” in “SETUP” to “PAL”.
[1] Press [VHS] and press [ 1, PLAY].
[2] Press [AUDIO] select the audio to be played (the
audio to be recorded) beforehand.
[3] Press [ ;, PAUSE] at the start point of the
recording.
[4] Press [DVD].
[5] Select “TP” channel with [CH, W, X].
≥The picture of the VHS is displayed on the TV.
≥When the “DC” channel is selected on VHS, you cannot select
the “TP” channel.
[6] Press [REC MODE] to select the recording
mode.
[7] Press [ ¥, DVD REC].
≥Disc recording and VHS play start at the same time.
∫ When dubbing is started, the following operations also
start automatically
≥“OSD” on VHS FUNCTIONS ) “OFF” (l 56)
Note
≥When “DVD / VHS Output” is set to “Manual” (
l 43), or when VHS
output is selected in starting dubbing, the output is switched to DVD
automatically at the time when dubbing is started.
≥When a Copy-guarded tape is inserted, the message appears on
the display and the recording stops on the spot.
≥Switching the audio mode by pressing [AUDIO]. The audio which
you are hearing is recorded.
∫ Manual Dubbing (VHS l DVD)
To pause or stop Manual Dubbing
You cannot stop or pause on DVD and VHS at the same time.
∫ To pause or stop recording
Press [DVD] and press [ ;, PAUSE] or [∫, STOP].
∫ To pause or stop play
Press [VHS] and press [ ;, PAUSE] or [∫, STOP].
∫About TP channel
(TP: Dubbing input channel)
When you select TP channel, DVD can receive the video/audio
signal from VHS. This enables you to dub the video played back
on VHS to DVD.
≥Press [DVD] and press [CH, W, X] several times to select TP
channel.
≥You can play back a tape in high picture quality (e.g.
Progressive, RGB Output) with TP channel. ( l 52)
≥Contrary to TP channel, DC channel is the channel for VHS to
receive the video/audio signal from DVD. ( l 61)
≥When the “DC” channel is selected on VHS, you cannot select
the “TP” channel.
VHS DVD
75VGN.book 59 ページ ２００４年７月２１日 水曜日 午前１１時５４分