Inserting a disc, Removing a disc, Forced disc eject – Panasonic SL-DZ1200 User Manual

Page 10

Advertising
background image

RQT7114

10

Basic operations

Inserting-removing a disc or SD Memory Card

Rear panel

Front panel

With the label
face up

Power lamp

Front panel

With the label
face up

SD ACCESS
indicator

SD Memory Card

Inserting a disc

1. Press [POWER

OFF

ON] on the rear of unit

The unit power is on. The display comes on and the power lamp
lights.

2. Insert a disc

•Insert the disc flat and parallel into the CD slot, with the label up.

The unit will automatically load the disc.

You cannot use an 8 cm disc.

Note

•Do not insert a disc when the power is off.
•Do not insert 2 or more discs.
•Do not try to insert the disc using unnecessary force that may bend

the disc. When the unit is loading or ejecting a disc, do not apply
opposing force to the disc. Not following the above steps may re-
sult in damage to the disc or unit.

Removing a disc

While stopped or while paused

1. Press [ CD EJECT]

•Press the button and the disc will come out.
•If you press while playing in TURNTABLE mode, a message ap-

pears in the display and play continues. Make sure to press af-
ter pausing play.

•If you do not remove the disc within approximately 10 seconds

the unit will automatically re-load the disc.

To remove

2. Press again

Remove as indicated in the illustration

without touching the playing surface.

Forced disc eject

You can forcefully eject a disc when the disc does not eject even after
pressing [ CD EJECT].

1. Press [POWER

OFF

ON] to turn the power off

2. Press [POWER

OFF

ON] again holding down

[ CD EJECT] to turn the power on, and then release
[ CD EJECT] after “DZ1200” appears in the display

Inserting a SD Memory Card

1. Open the SD Memory Card slot lid

2. With the label on the card facing up and the notched

edge facing the unit, insert the card

3. Insert until the card locks into place

4. Close the lid

Removing a SD Memory Card

After confirming the SD ACCESS indicator is not flash-
ing, open the lid and press on the center of the SD
Memory Card to release the lock and pull the ejected
card out carefully, then close the lid.

The SD ACCESS indicator flashes when the SD Memory Card

is being accessed. Do not turn off the power or try to open the lid
and remove the card while the indicator is flashing. (Doing so
may result in a loss of saved data.)

Note

Make sure to always close the SD card slot lid.

If you try using when the lid is open, “NO SD CARD” or “SD LID
OPEN” will appear in the display and operation will not be pos-
sible.

Playable media

CD

SD Memory Card

(SD audio)

CD-DA audio that is finalized on a
CD-R or CD-RW

MP3 files
(WMA is not supported)

Secure AAC

Secure MP3
(WMA is not supported)

25

12, 22

22

Reference

Page

Advertising