Pioneer Super Tuner III DVH-P7050 - Manual (Page 57)

Audio Adjustments
En 57
Fine adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (
EQ Low/EQ Mid/EQ High ).
1 Press A and hold unitil frequency and the
Q factor (e.g., F 80 Q 1W ) appears in the dis-
play.
• Pressing and holding
AUDIO on the head unit
also performs the same operation.
2 Press A to select the desired band for
adjustment.
Low—Mid—High
• Pressing
AUDIO on the head unit also per-
forms the same operation.
3 Select the desired frequency with
1 or ¡.
Press
1 or ¡ until the desired frequency
appears in the display.
Low
: 40 — 80 — 100 — 160 (Hz)
Mid : 200 — 500 — 1 k — 2 k (Hz)
High : 3.15 k—8 k — 10 k — 12.5 k (Hz)
• Pressing
2 or 3 on the head unit also per-
forms the same operation.
4 Press
E or e to select the desired Q
factor.
Press
E or e until the desired Q factor
appears in the display.
2 N — 1 N — 1 W — 2 W
• Pressing
5 or ∞ on the head unit also per-
forms the same operation.
Note
• If you make adjustments when a curve other
than CUSTOM2 is selected, CUSTOM1 curve
is updated.
Adjusting bass
You can adjust the cut-off frequency and the
bass level.
• In
FRT1 mode, bass adjustment affects only
the rear output: front output cannot be
adjusted.
1 Press A to select Bass .
Press A until Bass appears in the display.
• Pressing AUDIO on the head unit also per-
forms the same operation.
2 Select the desired frequency with
1 or
¡.
Press
1 or ¡ until the desired frequency
appears in the display.
40 — 63 — 100 — 160 (Hz)
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
3 Press
E or e to adjust the bass level.
Each press of
E or e increases or decreases
the bass level. +6 – –6 is displayed as the level is
increased or decreased.
• Pressing
5 or ∞ on the head unit also per-
forms the same operation.
English
Español
Deutsch
F
rançais
Italiano
Nederlands
08
Section
Level (dB)
Center frequency Frequency (Hz)
Q=2N
Q=2W