Pioneer Super Tuner III DVH-P7050 - Manual (Page 85)

Error messages
When problems occur with disc playback, an
error message appears on the display. Refer to
the table below to identify the problem, then
take the suggested corrective action. If the error
persists, contact your dealer or your nearest
PIONEER Service Center.
Error massages on the OEL display
Error massages on the display
Additional Information
En 85
English
Español
Deutsch
F
rançais
Italiano
Nederlands
12
Section
Message Cause Action
ERROR-02 The disc is dirty. Wipe the disc
clean. (See page
79.)
THERMAL
PROTECTION
IN MOTION
The tempera-
ture of this unit
is outside of the
normal operat-
ing range.
Wait until the
unit’s tempera-
ture returns to
within normal
operating limits.
The disc is
scratched.
If the disc is
scratched,
replace it with
another. (See
page 79.)
DIFFERENT
REGION DISC
The disc does
not have the
same region
number as this
unit.
Replace the
DVD with one
bearing the
correct region
number.
NON-
PLAYABLE
DISC
This type of disc
(CD-ROM etc.)
cannot be
played by this
unit.
Replace the
disc with one
this unit can
play. (See page
77.)
The disc is
loaded upside
down.
Check that the
disc is loaded
correctly.
Message Cause Action
ERROR-11, 12,
17, 30 Dirty disc Clean disc.
ERROR-11, 12,
17, 30 Scratched disc Replace disc.
ERROR-14 Blank disc Check the disc.
ERROR-10, 11,
12, 14, 17, 30,
A0 Electrical or
mechanical Turn the ignition
ON and OFF, or
switch to a
different source,
then back to the
built-in player.
ERROR-44 All tracks are
skip tracks. Replace disc.