Pure Digital Pure Contour Air 200i - Manual (Page 16)

16
Connection
The Connection tab is divided into two main sections, Contour Name Assignment and Wireless
Setup.
1. Select ‘Configure Manually’ from the Network drop-down list and select the encryption
type of your wireless network from the drop-down list below. Contour supports the following
encryption types:
• No Encryption Select this option if your wireless network is unsecured.
• WEP Select this option if your wireless network is being secured using the
Wired Equivalent Privacy (WEP) method.
• WPA Select this option if your wireless network is being secured using the
Wi-Fi Protected Access (WPA) method.
• WPA2 Select this option if your wireless network is being secured using the
Wi-Fi Protected Access II (WPA2) method.
Note: Please check your wireless router configuration to find out the type of encryption that
is being used on your wireless network.
2. Enter the passphrase/key needed to connect to your network in the box below, if one is
required.
3. Click Connect. The Status LED will then flash red to indicate that Contour is resetting. When
Contour has started up it will enter Sleep mode.
Contour Name
Assignment
Wireless Setup
Contour name assignment
See page 9 for more information on how to assign a unique name for Contour.
Automatic wireless setup
See page 9 for information on automatic wireless setup.
Manual wireless setup
If your wireless network is not broadcasting an SSID, you will need to configure your wireless
settings manually.