Panasonic AJ-D850P - Manual (Page 67)

– 67 –
USER menu
<TAPE PROTECT>
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
400 STILL 0000 0.5s
TIMER 0001 5s
0002 10s
0003 20s
0004 30s
0005 40s
0006 50s
0007 1min
0008 2min
401 SRC 0000 STEP
PROTECT 0001 HALF
402 DRUM 0000 OFF
STDBY 0001 ON
403 STOP 0000 STEP
PROTECT 0001 HALF
The underline on the setting item denotes the initial setting.
<Note>
In order to protect the tape and VTR helical heads, it is recommended that the Still Timer be
set for automatic tape protection mode in 30 seconds or under.
This selects the time to be taken until the unit goes into the
tape protection mode when it is left standing in the stop or
search still (JOG/VAR/SHTL) mode. (Unit: s = second, min =
minute)
<Note>
With the DV or DVCAM format, the maximum time which can
be set is 10 s even when a setting above 10 s has been
selected. The selection screen, however, will operate for up to
2 minutes.
This selects the operation during the tape protection mode
when the unit is left standing in the still status during the
search mode (JOG/VAR/SHTL).
0: STEP FWD.
1: HALF LOADING.
<Note>
When STEP FWD is selected, the unit automatically goes into
the HALF LOADING mode when the total time for which the
unit is left standing in the still status reaches 30 minutes
(DVCPRO) or 1 minute (DV or DVCAM).
This selects the drum operation in the STANDBY OFF mode.
0: The drum stops rotating.
1: The drum continues rotating.
This selects the operation in the tape protection mode when
the unit has been left standing in the STOP mode.
0: STEP FWD
1: HALF LOADING
<Note>
When STEP FWD is selected, the unit is automatically
transferred to the HALF LOADING mode when the total time
during which it has been left standing in the STOP mode
reaches 30 minutes (or 1 minute with a DV/DVCAM tape).
<TIME CODE>
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
500 VITC 0000 10L
POS-1 0001 11L
0002 12L
0003 13L
0004 14L
0005 15L
0006 16L
0007 17L
0008 18L
0009 19L
0010 20L
The underline on the setting item denotes the initial setting.
This sets the position where the VITC signal is to be inserted.
(The same line as for VITC POS-2 in 501 cannot be selected.)