Panasonic AJ-D850P - Manual (Page 73)

– 73 –
USER menu
<AUDIO> (continued)
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
723 DV PB ATT 0000 OFF
0001 ON
724 MONI SEL 0000 OFF
INH 0001 ON
725 CUE SLOW 0000 STEP
0001 LINEAR
726 CUE OUT 0000 NORMAL
0001 DIRECT
727 MONI MIX L 0000 OFF
0001 CH1+2
728 MONI MIX R 0000 OFF
0001 CH1+2
729 REC PT 0000 OFF
MUTE 0001 ON
730 CUE OUT 0000 OFF
SEL 0001 ON
The underline on the setting item denotes the initial setting.
This selects the audio output level for DV or DVCAM format
playback.
0: The audio output level is not attenuated.
1: The audio output level is attenuated (reduced).
<Notes>
As indicated below, whether the setting takes effect or not
depends on the size of the cassette tape used.
1. When an “L” size cassette is used
The setting takes effect only when “DV” or “DVCAM” has
been selected as the setting for setup menu No. 108
(FORMAT SEL).
2. When an “M” size cassette is used
The setting does not take effect.
3. When an “S” size cassette used
The setting takes effect.
This selects whether to allow (enable) or prohibit (disable) the
operation of the MONITOR SELECT and MONITOR SET
buttons on the front panel.
0: The buttons can be operated.
1: Operation of the buttons is prohibited.
This selects the tape travel status (CUE track playback status)
during SLOW playback.
0: Priority is given to the output picture, and tape travel is set
to the step feed status.
1: Priority is given to CUE track playback, and the tape travel
is set to the linear status.
<Notes>
When “1” (LINEAR) has been set:
• It may not be possible to achieve as clear a picture as in the
STEP mode.
• The CTL counter may not operate properly.
This selects the output signals from the CUE OUT connector.
0: The timing is aligned with the output picture.
1: The signals recorded on the tape are output with no delay.
<Note>
When “1” (DIRECT) has been set, the output picture and CUE
output timing will differ.
This enables mixed signals to be selected for the monitoring
through the headphones.
0: The signals are not mixed.
1: The CH1 and CH2 signals are mixed and output to the left
channel.
This enables mixed signals to be selected for the monitoring
through the headphones.
0: The signals are not mixed.
1: The CH1 and CH2 signals are mixed and output to the right
channel.
This selects whether to mute the sound at the joins in the
recording during playback in the DV or DVCAM format.
0: The sound is not muted.
1: The sound is muted.
This selects whether the cue signal is to be output to the main
line system output in the search mode.
0: The cue signal is not output.
1: The cue signal is output.
(This applies only when a setting other than MANU has been
selected for setup menu item No. 713 (MONI CH SEL).)