Panasonic AJ-D850P - Manual (Page 91)

– 91 –
SERVO CONTROL
ERROR
Counter display Description
VTR operation
(Restart condition)
REEL DIR UNMATCH If the reel motor at the take-up side is running in the
reverse direction, the AUTO OFF lamp lights, and the
message display flashes.
STOP
(POWER OFF
ON)
REEL TENSION ERROR
SERVO COMM ERROR
SERVO ERROR
S-FF/REW TIMEOVER
S REEL ROTA TOO
FAST
T REEL ROTA TOO
FAST
T REEL TORQUE
ERROR
UNLOAD ERROR
S REEL TORQUE
ERROR
WINDUP ERROR
If an abnormal tension at the supply side is detected
in the reel mode, the AUTO OFF lamp lights, and the
message display flashes.
STOP
(POWER OFF
ON)
When the servo microcomputer does not follow the
instructions of the system control microcomputer
even when 10 seconds have elapsed, the AUTO OFF
lamp lights, and the message display flashes.
STOP
(POWER OFF
ON)
When there is no response from the servo micro-
computer for 1 or more seconds, the AUTO OFF
lamp lights, and the message display flashes.
STOP
(POWER OFF
ON)
When only the servo microcomputer was reset in an
instantaneous power failure, the AUTO OFF lamp
lights, and the message display flashes.
STOP
(POWER OFF
ON)
If the start/end processing operation is not completed,
the AUTO OFF lamp lights, and the message display
flashes. STOP
(POWER OFF
ON)
If the supply reel motor should rotate at an ab-
normally fast rate, the AUTO OFF lamp lights, and
the message display flashes.
STOP
(POWER OFF
ON)
If an abnormal torque applied to the supply reel motor
is detected, the AUTO OFF lamp lights, and the
message display flashes.
STOP
(POWER OFF
ON)
If the take-up reel motor should rotate at an ab-
normally fast rate, the AUTO OFF lamp lights, and
the message display flashes.
STOP
(POWER OFF
ON)
If an abnormal torque applied to the take-up reel
motor is detected, the AUTO OFF lamp lights, and
the message display flashes.
STOP
(POWER OFF
ON)
If the tape has not been wound up during unloading,
the AUTO OFF lamp lights, and the message display
flashes.
STOP
(POWER OFF
ON)
If the tape was not wound up at less than the
standard speed (1
×
) when the total tape amount was
not detected or if abnormal tape slack or tension was
detected at speeds above 1
× after the total tape
amount was detected, the AUTO OFF lamp lights,
and the message display flashes.
STOP
(POWER OFF
ON)
WINDUP REEL NOT
ROTA If, after the cassette has been inserted, the tape take-
up reel has not wound up the tape at the standard
speed (1
×
) or faster while the total tape amount is not
detected and while the tape is traveling in the forward
or reverse direction, the AUTO OFF lamp lights, and
the message display flashes.
STOP
(POWER OFF
ON)
Monitor display
SERVO CONTROL
ERR
REEL DIR UNMATCH
REEL TENSION ERROR
SERVO COMM ERROR
SERVO ERROR
S-FF/REW TIMEOVER
S REEL TOO FAST
T REEL TOO FAST
T REEL TORQUE
ERR
UNLOAD ERROR
S REEL TORQUE
ERR
WINDUP ERROR
W-UP REEL NOT ROTA