Panasonic DX-600 - Manual (Page 187)

Relayed Transmission
187
Ne
tw
or
k
Fe
at
ur
e
s
Once you have recorded all the necessary parameters in your machine, you can send a document to one or
multiple G3 fax machines automatically through the Internet Relay Station by using the procedure described
below. The Internet Relay Station must have all the necessary parameters setup.
To a Location That Has a Pre-programmed Relay Station
NOTE 1. If the Relay Station requires a special access number to get an outside line, enter that access
number first then press to enter a pause (represented by a "-") before entering the
full number.
Sending Documents via Internet Relay
1
Set document(s) face down.
ENTER STATION(S)
THEN PRESS START 00%
2
Enter only the telephone number(s) of the End Receiving
Station(s) using any combination of the following methods:
• One-Touch Dialling
• Abbreviated Dialling
• Manual Number Dialling (up to 70 stations), press
after each station is entered. (see Note)
• Directory Search Dialling, press after each station is
entered
(For details, see pages 91 to
94.)
Ex:
<02> STOCKHOLM
4681111234
3
The document(s) is stored into memory and your machine
starts sending the document(s) to the Relay email address
of the Relay Station with the telephone number for the End
Receiving Station.
Ex: End Receiving Station : 4681111234
(Telephone number)
[see Note 1]
Relay Station : [email protected]
After the Relay Station completes its transmission to the
End Receiving Station(s), your machine receives a COMM.
Journal from the Relay Station.
This Journal confirms whether the Internet Relayed
Transmission was successful.
* STORE * NO.002
PAGES=001 05%
* STORE * COMPLETED
TOTAL PAGES=005 25%
ON LINE *MEM.XMT*
ID:uk-rly#4681111234
SET
PAUSE