Pioneer VSX-D514 - Manual (Page 12)

5 minute guide 02
12
En
Using the Quick Setup
You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position.
If you want to make more specific settings,
refer to
Choosing your receiver setup on
page 44.
Use the front panel controls for the steps
below.
1 If the receiver is off, press
STANDBY/ON to turn the power on.
2 Press QUICK SETUP.
VSX-D714/D814 only – SW DET flashes in the
display while the receiver checks your setup
for a subwoofer.
SW YES or SW NO confirms
the subwoofer check, then the display
prompts you to select your speaker setup.
3 Use the MULTI JOG dial to choose your
speaker setup.
VSX-D714/D814 – When a subwoofer was
detected in step 2, you can cycle between the
following choices:
* VSX-D814 only
If a subwoofer wasn’t detected in step 2, you
can cycle between the following choices:
* VSX-D814 only
VSX-D514 – Cycle between the following
choices:
• Check the table below to find the speaker
setup that corresponds with your system.
* VSX-D714/D814 only
** VSX-D814 only
UP DOWN
MULTI JOG
MASTER VOLUME
ENTER
SPEAKERS
S-VIDEO DIGITAL IN VIDEO L AUDIO R
ADVANCED
SURROUND STEREO/ DIRECT SIGNAL
SELECT MIDNIGHT/ LOUDNESS SB CH
MODE
TENING MODE
TONE QUICK SETUP
MMER
VIDEO INPUT
MULTI JOG
7.1ch* 4.1ch
6.1ch 5.1ch
2.1ch 3.1ch
7.0ch* 4.0ch
6.0ch 5.0ch
2.0ch 3.0ch
5.1ch
2.0ch 4.0ch
5.0ch 4.1ch
2.1ch 3.0ch 3.1ch
VSX_514-814.fm 12 ページ ２００４年３月２日 火曜日 午後８時３５分