Pioneer VSX-D514 - Manual (Page 25)

Connecting up 03
25
En
English
Italiano
Français
Nederlands
Español
Deutsch
• To hear sound only from the pre-outs,
disconnect any speakers that are
connected directly to the receiver.
• If you’re not using a subwoofer, change
the front speaker setting (see Speaker
setting on page 46) to large.
• VSX-D714 only – If you connect to a
surround back speaker, make sure the
Surround back speaker setting on page 46
is switched on and set to the proper
speaker size.
• These speaker terminals are hazardous
when live. To prevent the risk of electric
shock when connecting or disconnecting
the speaker cables, disconnect the power
cord.
Power cord caution
Handle the power cord by the plug. Do not
pull out the plug by tugging the cord and
never touch the power cord when your hands
are wet as this could cause a short circuit or
an electric shock. Do not place the unit, a
piece of furniture, etc., on the power cord, or
pinch the cord. Never make a knot in the cord
or tie it with other cords. The power cords
should be routed such that they are not likely
to be stepped on. A damaged power cord can
cause a fire or give you an electrical shock.
Check the power cord once in a while. When
you find it damaged, ask your nearest Pioneer
authorized service center or your dealer for a
replacement.
Operating other Pioneer
components
VSX-D714/D814 only
By connecting a control cord (optional), you
can point the remote controls of other Pioneer
components at the receiver’s remote sensor.
The remote control signals are received by the
remote sensor of this unit, and sent to the
other devices via the
CONTROL OUT terminal
of the receiver.
CONTROL
OUT
IN OUT
IN
CONTROL
Receiver
Remote
control
unit
Other Pioneer products
with CONTROL terminals
Connect to CONTROL
terminal of other
compatible Pioneer products
VSX_514-814.fm 25 ページ ２００４年３月２日 火曜日 午後８時３５分