Pioneer VSX-D514 - Manual (Page 52)

Setting up the receiver 06
52
En
Function setting for VIDEO input
• VIDEO:1 – VIDEO:5 or TV – Matches the
VIDEO function of the receiver with a
numbered video input on the plasma
display. For example,
VIDEO:4 matches
the VIDEO input with video input 4 on the
plasma display.
Manually calibrating your
listening area (MCACC)
VSX-D714/D814 only
You can use the Multichannel Acoustic Cali-
bration (MCACC) system to fine tune your
speaker levels and channel delay. These are
calibrated according to the distance from
your left front speaker to the listening posi-
tion. You will hear a series of test tones that
will allow you to set the speaker levels and
channel delay to your liking. The advantage of
doing this is that you can achieve an overall
balance defined by the front speakers (the
main speakers for home theater).
• These test tones can be loud, so take care
that there is no one in the room who will
be startled by the noise.
• You must complete the Speaker setting on
page 46 before using the MCACC setup.
1 Press RECEIVER.
2 Press MCACC SETUP.
The MCACC system uses the left front
speaker as a reference point to calibrate the
speaker level and channel delay.
The front left speaker tone and the target
speaker (the one that you’re trying to adjust)
tone will sound in turns, so you can judge
which needs to be louder.
3 Use and to adjust each channel
level in turn, pressing ENTER to go to the
next channel when you’re done.
The test tone is output in the following order
(depending on the speaker setting):
4 Specify the distance from the front left
speaker to your listening position using
and then press ENTER.
MCACC
SETUP
ENTER
RECEIVER
R C
RS
LS
SW SB
VSX_514-814.fm 52 ページ ２００４年３月２日 火曜日 午後８時３５分