Panasonic AG-AC160AEN - Manual (Page 77)

77
Displays
12 Media information display
Displays basic information about inserted
memory cards. Information regarding slot 1 is
displayed above, and information regarding slot
2 is displayed below.
[
1 ] [ 2 ]:
Recordable memory card (white)
• Displayed in green if used for recording.
[ ]:
Write protect is on
[ ]:
Non-recordable memory card
[ ]:
Memory card is full
• Recording is sometimes possible even when
this icon is displayed.
• Depending on the space and type of
memory card, this icon may not be displayed
even if recording stops while shooting
because the memory card is full.
[ ]:
Playback only memory card
Memory cards with more than 1000 clips
recorded become playback only memory
cards.
[ ]:
No memory card inserted in both memory
card slots 1 and 2
• Flashes red.
13 Metadata recording display (AVCHD mode
only)
[
META ]: When metadata recording is [ON]
No display:When metadata recording is [OFF]
14 Recording format display (Page 89)
15 System frequency display
Displays system frequency.
[
60
]: When [SYSTEM FREQ] = [59.94Hz]
[
50
]: When [SYSTEM FREQ] = [50Hz]
16 Marker luminance display
During marker display, the image level near the
center of the screen is displayed as [0%] - [99%].
[99%] is displayed when [99%] is exceeded.
• When the AREA Y-GET function is operating,
the image level near the center of the AREA
frame is displayed. (Page 25)
17 Frame rate display
Displays the recording frame rate.
Not displayed when 1080/60i, 1080/50i.
18 Audio limiter display
Displays when the AUDIO AUTO/MANU CH1/
CH2 switch is set to <MANU>, and the [AUDIO
LIMITER CH1]/[AUDIO LIMITER CH2] items on
the setup menu [RECORDING SETUP] screen
are [ON].
[
AL CH 1 ]: When [AUDIO LIMITER CH1] = [ON]
[ AL CH 2 ]: When [AUDIO LIMITER CH2] = [ON]
[ ALCH1 2 ]: When [AUDIO LIMITER CH1],
[AUDIO LIMITER CH2] = [ON]
19 Recording audio type display (AVCHD mode
only)
[
LPCM ]: During [LINEAR PCM] recording
[ ]: In VFR recording, an indication
appears to show that audio is not
recorded. Audio is not output from
the external output terminals in
VFR recording. Also, the audio level
meter does not work.
No display: Dolby Digital recording
20 Remaining battery charge display
When using Panasonic batteries compatible
with this camera, the remaining battery charge
is displayed in minutes. Some time passes until
displayed.
• As the remaining battery charge becomes
lower, the display changes to [
]
 [ ][ ][ ][ ].
When there are less than 3 minutes [ ]
flashes in red, and when there is no capacity
[
] flashes.
• The remaining battery charge may not be
displayed correctly when used in high or low
temperatures, or when the camera has not
been used for a long period of time. To display
the remaining battery charge correctly, fully
charge the battery and recharge it after using
it completely. (Even when doing so, batteries
used for lengthy periods in high and low
temperatures or those repeatedly charged
sometimes do not display the battery level
correctly.)
• Since the time on the battery level display
may vary depending on usage conditions, use
it as a guideline.
• When switching modes, performing REC
CHECK, or changing the LCD brightness, the
time display will disappear for a moment to
recalculate the remaining battery charge time.
• Not displayed when using an AC adaptor.