Main warning displays – Panasonic AG-AC160AEN User Manual
Page 80
80
Main warning displays
The main warning displays appearing on the LCD monitor or viewfinder are as follows. If a warning display
is not listed, carefully check the message displayed.
A
[ALL DATA WILL BE DELETED. (INCLUDING
CLIP OF AVCHD) FORMAT THE CARD NOW?
(SLOT1)]
If you format the memory card, all the recorded
data will be deleted. (Including AVCHD clips.)
Do you format the memory card? (SLOT1)
C
[CANNOT BE USED DUE TO INCOMPATIBLE
DATA.]
Cannot be used because the standard for the data
is different.
[CANNOT DELETE.]
Clip cannot be deleted.
[CANNOT DELETE WITH THIS BUTTON]
Clip cannot be deleted.
[CANNOT PLAY.]
No playback is possible.
[CANNOT PLAY WITH THIS BUTTON]
No playback is possible.
[CANNOT RECORD PH MODE INTO THIS
CARD. PLEASE CHANGE THE REC FORMAT.]
This memory card cannot be recorded to in PH
mode. Change the recording format.
[CANNOT RECORD. THE NUMBER OF CLIPS
HAS EXCEEDED THE MAXIMUM LIMIT.]
The maximum number of clips has been reached
and no further clips can be recorded.
[CANNOT SET THE NUMBER OF INDEXES
HAS EXCEEDED THE MAXIMUM LIMIT.]
No further indexes can be set because the number
of indexes will exceed the maximum limit.
[CANNOT SET PRE-REC, CARD CAPACITY
TOO LOW.]
PRE-REC cannot be set because the remaining
memory card capacity is low.
[CARD DOOR OPENED.]
The memory card door is open.
[CARD ERROR. PLEASE REFORMAT.]
Formatting has failed. This memory card needs to
be reformatted.
[CARD FULL.]
The memory card is full.
[CHECK CARD.]
Please check the memory card.
If a memory card that has been used before in
another device or computer is used for the first
time in this camera, [CHECK CARD.] is displayed,
and all operations may be disabled.
In such a case, perform the following:
1) Remove the memory card from the camera and
The camera recognizes the memory card and
cancels the [CHECK CARD.] display.
2) If the [CHECK CARD.] display is not disappeared
even after removing and inserting the memory
card several times, check the contents of the
memory card on a computer, and erase all the
data.
3) Format the memory card with the camera.
If the data on the memory card cannot be either
read or erased on a computer, the memory card
may be damaged. Use another memory card.
[CONTROL DATA ERROR HAS BEEN
DETECTED.]
An error has been detected in the control
information.
D
[DISCONNECT USB CABLE.]
When turning off the power, disconnect the USB
connection cable.
I
[INCOMPATIBLE CARD. PLEASE CHECK
CARD.]
Displayed when the writing speed of the memory
card in use is slow and recording may not be
performed.